Fluke 8846A User Manual

Contents (continued)
iii
Physical Layer Wiring Schemes Supported by the Meter ............................. 106
Network Interconnection Devices ................................................................. 107
Basic Network Packet and Frame Contents .................................................. 107
IP Addresses and Segmented Networks ........................................................ 108
TCP/IP Protocol Stack................................................................................... 110
Introduction........................................................................................................ 113
Device Dependent Command Set ...................................................................... 113
Calibration Commands ...................................................................................... 113
Dn (Display Commands) ................................................................................... 114
Gn (Get Commands).......................................................................................... 114
Tn (Trigger Mode Commands).......................................................................... 114
Wn (Terminator Commands)............................................................................. 114
Numeric Entry Command.................................................................................. 114
Talk-Only Mode ................................................................................................ 114
Ranging in 8842A Emulation Mode.................................................................. 114
Operational Differences..................................................................................... 115
Appendices
A Error Codes ................................................................................................ 95
B Fluke 45 Emulation Limitations.................................................................. 103
C Network Consideration................................................................................ 105
D Fluke 8842A Emulation Limitations........................................................... 113

Fluke 8846A Specifications

General

Frequency Range	3 Hz to 300 kHz
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
Resistance Range	10 Ω to 1 GΩ
Continuity	Yes
Diode Test	Yes
Temperature Measurement	Yes
Display	5.5 digit
Connectivity	USB, RS-232, GPIB
DC Current Range	100 µA to 10 A
AC Current Range	100 µA to 10 A
Frequency Accuracy	0.01 %
Capacitance Range	1 nF to 100 µF
Display Type	VFD
Power Supply	100 V to 240 V
AC Voltage Accuracy	±(0.06% + 0.03% of reading)
Resistance Accuracy	±(0.01% + 0.001% of reading)