902
Users Manual
14
1. Connect the 80BK Integrated DMM Temperature
Probe to the input jacks noting correct polarity of the
probe.
2. Turn the rotary switch to F.
3. Press A to select °C or °F. The display reflects the
chosen temperature mode.
4. Position the probe to take the measurement. The
reading appears on the display.
Note
To meet stated accuracy, the 80BK and Meter
must be at the same temperature.
XW Warning
To avoid possible electric shock DO NOT apply
the probe tip to any conductor that is greater
than 30 V ac, 42 V peak or 60 V dc to earth.
To Next Page
Loading...
