HVAC Clamp Meter
Maintenance
21
Battery Replacement
XWWarning
To avoid false readings that could lead to
possible electric shock or personal injury,
replace the batteries as soon as the low
battery indicator (B) appears.
Disconnect the test leads before replacing the
batteries.
To replace the batteries (refer to Figure 6):
1. Turn the rotary switch to “OFF” and remove the test
leads from the terminals.
2. Use a Phillips screwdriver to loosen the battery
compartment door screw, and remove the door from
the case bottom.
3. Remove the batteries.
4. Replace the batteries with two new AA batteries.
5. Reattach the battery compartment door to the case
bottom and tighten the screw.
To Next Page
Loading...
