11
Operation
Operation
To use the Voltage Detector, do the following:
1
Before using the Voltage Detector, always perform a self check (see “Self
Check” on page 8).
2
Remove the black conductive end cap from the probe tip. Be careful not
to unscrew the front and rear housing while removing the cap.
3
Hold the Voltage Detector as shown in Figure 4.
4
Use your bare hand (except when gloves are required) to grasp the rear
housing and your thumb to operate the trigger.
EMU04.EPS
Figure 4. Holding the Voltage Detector
To Next Page
Loading...
