CERTIFIBER ENGLISH - 12
rapidly and then continuously to indicate
that CERTIFIBER REMOTE provides a consistent
lightsource for the wavelength indicated.
Press the Battery button to turn the
lightsource off. Press and hold the battery
button to switch to the other wavelength.
Battery
CERTIFIBER and CERTIFIBER REMOTE each require
three AA alkaline batteries. If CERTIFIBER and
CERTIFIBER REMOTE will be stored for more than
one month, the batteries should be removed.
To conserve battery life, CERTIFIBER will turn off
automatically when no key has been used for
10 minutes.
Note
CERTIFIBER and CERTIFIBER REMOTE will not function
properly with carbon batteries. Alkaline
batteries are required.
Note
Stored Autotests and setup parameters are
stored in flash memory. They are not affected
by the battery status.
Battery Check
To check CERTIFIBERs battery:
1. Connect the CERTIFIBER to the REMOTE unit
using a launch cable.
2. Turn both units on.
3. Press F2 to display the About screen.
The Version Info screen displays CERTIFIBER and
CERTIFIBER REMOTEs remaining Battery power,
All manuals and user guides at all-guides.com
To Next Page
Loading...
