CERTIFIBER ENGLISH - 13
the Serial #, and the Hardware and Soft-
ware Versions.
To change batteries, slide off the battery
cover located on the back of each unit.
Replace the three AA alkaline batteries and
position them according to the display in the
battery case.
Connector Adapters
CERTIFIBER has one ICA connector port (TX) and
one threaded optical receiver port (RX) which
accepts different connector adapters.
Attach the included connector adapters to
the CERTIFIBER and CERTIFIBER REMOTE RX receiver
ports before connecting jumpers.
Note
Keep the connectors covered when the units
are not in use.
Both units have covers to protect the
connectors from dirt. Keep the adapters
covered when the units are not in use.
This helps to ensure that contaminants
from handling fiber do not affect test
measurements.
Technical Support
Visit the Fluke Networks website at
www.flukenetworks.com. Send email to
fluke-assist@flukenetworks.com.
To order accessories or get the location of the
nearest Fluke Networks distributor or service
All manuals and user guides at all-guides.com
To Next Page
Loading...
