DTX-MFM2/GFM2/SFM2 Fiber Modules
Users Manual
4
Safety Information
WWarningX
To avoid possible fire, electric shock, or personal
injury read the safety information given in the
DTX Series CableAnalyzer Users Manual.
WWarning: Class 1 and Class 2 Laser
Products
*
To avoid possible eye damage caused by
hazardous radiation:
•
Never look directly into optical connectors. Some
sources produce invisible radiation that can
permanently damage your eyes.
•
Keep the fiber module’s OUTPUT port covered
with a dust cap or keep a test reference cord
attached. The OUTPUT port may be active even
when a test is not in progress. Covering the port
reduces the risk of accidental exposure to
hazardous radiation.
•
Never start a test or activate the OUTPUT port or
VFL port without first connecting a fiber to the
port you will use.
•
Never look directly into the visual fault locator
output. Momentary exposure to the locator’s
output will not damage your eyes; however,
direct, long-term exposure is potentially
hazardous.
•
Do not use magnification to view the optical
outputs without proper filtering.
•
Use of controls, adjustments, or procedures not
stated herein might result in hazardous radiation
exposure.
WCaution
To avoid damaging the tester or cables under
test, to avoid data loss, and to ensure maximum
accuracy of test results:
•
Leave the module bay covers in place when the
fiber modules are not installed.
•
Turn off the tester before attaching or removing
modules.
To Next Page
Loading...
Need help?
General
