63
Appendix C: Modified 1 Jumper Method
This Appendix shows modified reference and test
connections that produce 1 Jumper results. Use these
connections if you need 1 Jumper results but do not have
connector adapters that match the connectors in the fiber
under test. This method lets you connect to the fiber
without disturbing the fiber modules' output connections
after setting the reference.
Figures C-1and C-2 show reference and test connections
for a fiber with MT-RJ connectors.
To test links with different connectors at each end visit the
Fluke Networks Knowledge Base for suggestions.
To Next Page
Loading...
