1
DTX-MFM2/GFM2/SFM2 Fiber Modules
Overview of Features
The DTX-MFM2, DTX-GFM2, and DTX-SFM2 fiber modules
are used with a DTX Series CableAnalyzer to test and
certify fiber optic cabling installations. The fiber modules
offer the following functions and features:
•
Measures optical power loss and length on dual-fiber
cabling. The DTX-MFM2 tests multimode cabling at
850 nm and 1300 nm. The DTX-SFM2 tests singlemode
cabling at 1310 nm and 1550 nm. The DTX-GFM2
features a VCSEL for testing multimode cabling at
850 nm and 1310 nm when a VCSEL source is required.
•
Each module transmits both wavelengths (850 nm and
1300 nm, 850 nm and 1310 nm, or 1310 nm and
1550 nm).
•
Interchangeable connector adapters allow reference
and test connections that meet ISO and TIA standards
for most SFF (small form factor) fiber connectors.
•
Provides pass/fail results based on industry-standard
limits.
•
Visual fault locator helps you locate breaks, bad
splices, bends, and check fiber continuity and polarity.
•
FindFiber
™
function helps you identify and verify fiber
connections.
Note
The fiber modules are not compatible with the DTX-ELT.
Registration
Registering your product with Fluke Networks gives you
access to valuable information on product updates,
troubleshooting tips, and other support services. To
register, fill out the online registration form on the Fluke
Networks website at www.flukenetworks.com/registration.
To Next Page
Loading...
Need help?
General
