Fluke DTX-MFM2 - Fiber Test Settings

Fiber Test Settings
15
Fiber Test Settings
Table 2 describes the test settings that apply to fiber
cabling.
To access the fiber test settings turn the rotary switch to
SETUP; then select Fiber Loss. Use
BC to see different tabs.
Table 2. Fiber Test Settings
-continued-
Setting Description
SETUP > Fiber Loss >
Fiber Type
Select a fiber type that is appropriate for the type you will test. Selecting Custom lets you
create a fiber type. See the Technical Reference Handbook for details.
SETUP > Fiber Loss >
Test Limit
Select the appropriate test limit for the job. The tester compares the fiber test results to the
selected test limit to produce PASS or FAIL results. Selecting Custom lets you create a test limit.
See the Technical Reference Handbook for details.
SETUP > Fiber Loss >
Remote End Setup
Use Smart Remote mode for testing dual-fiber cabling.
Use Loopback mode for testing test reference cords and cable spools.
Use Far End Source mode with an optical source for testing individual fibers.
Downloaded from Elcodis.com electronic components distributor