Autotest and Central Setup
Introduction
2
2-3
The Network Assistant will identify as a router any device
advertising one of the following router protocols: RIP,
IGRP, EIGRP, IRDP, or OSPF.
Therefore, if a router is statically configured (i.e., is not
sending out routing updates), it may not show up as a
router.
The Network Assistant will identify any IP device that is
transmitting periodic router updates as a router. Therefore,
the Network Assistant identifies a workstation that is
inadvertently configured as a router.
Device Icons
Pressing a flashing device icon displays a popup screen
that shows information about problems with that device.
Close the popup window by pressing
. The device
icons are described in Table 2-1.
To Next Page
Loading...
