4-1
Chapter 4
Cable Tests
Introduction
The Network Assistant quickly identifies the most
common cable and wiring faults on twisted pair cabling
systems and automatically tests all four pairs. It also
detects fiber optic cable and enables you to begin fiber
tests if a fiber optic module is detected.
You can perform the following tests and operations from
the Cable Tests display (Figure 4-1).
Run Cable Autotest
Verify pin-to-pin continuity (wiremap)
Transmit toner
Fiber tests
Set units (feet or meters) and define category of
cable under test
Read the “Basic Cable Concepts” section for more
information.
ace401s.bmp
Figure 4-1. Cable Tests
To Next Page
Loading...
