Fluke Series II - Conducting a Ping Station Test

OneTouch Series II
Users Manual
6-4
Conducting a Ping Station Test
After you have configured the appropriate IP address, you
can set the frame length from the by pressing
or
(Figure 6-5).
This sets the frame length of the ping packet between 64
and 1518 bytes. This is the total frame length.
Press
(Begin Pinging) from the IP Ping or NetWare
Ping display (Figure 6-7) to start the test.
Figure 6-7 shows a sample IP Ping test results screen.
Figure 6-8 shows an example of NetWare ping test
results.