Accessories
Visit the Fluke Networks website at www.flukenetworks.com for
a complete list of fiber test equipment and accessories.
Specifications
Operating temperature -10ºC to +50ºC
Storage temperature -20ºC to +50ºC
Emitter type FP laser: dual 1310 nm/1550 nm
Central wavelength 1310 nm, 1550 nm
Wavelength accuracy 1310 nm: ±20 nm
1550 nm: ±30 nm
Spectral bandwidth (RMS) 1310 nm: 2 nm (maximum)
1550 nm: 3 nm (maximum)
Minimum output power 1310/1550 nm: ≥ -7 dB (typical)
Power output stability
1
±0.25 dB over 8 hours
Auto dual-wavelength
switching
Yes. Can be enabled or disabled
by the user.
Optical connector Fixed SC
FindFiber ID generation Yes. Fixed at ID 2.
Output modes CW (continuous wave), 2 kHz
modulated, auto-wavelength
Power requirement 2 AA alkaline batteries
Battery life
2
30 hours (typical)
Automatic power-off 30 minutes (can be disabled by
the user)
Low battery warning Blinking LED
Size 5.6in x 3.2in x 1.6in
(14.2 cm x 8.1 cm x 4.1 cm)
Weight 9.8 oz (278 g)
1. 23°C ±2°C, after 5 minutes of warm-up time.
2. In auto-wavelength mode. Battery life depends on the condition
and type of batteries used. Fluke Networks recommends alkaline
batteries.
To Next Page
Loading...
