Fluke TiS10 - Voice Annotation (Recording)

Performance Series Thermal Imagers
Image Capture
13
stored in the file so you do not need to collate multiple files
at a later time.
To add photos using the IR-PhotoNotes annotation
system:
1. With an infrared image in the buffer, push  to open
the EDIT IMAGE menu.
2. Push W/X to highlight IR-PhotoNotes.
3. Push  to enter the Picture mode.
4. Focus the Imager on the object and push the Image
Capture button.
5. Push  when done.
6. Push the Image Capture button to capture additional
pictures.
7. Push  save the pictures with the image.
i
Voice Annotation (Recording)
A Bluetooth headset (sold separately) is required and the
radio must be enabled for voice (audio) recording. This
feature may not be available in all regions. (Not available
on the TiS10 and TiS20 models.)
To record:
1. With an infrared image in the buffer, push  to open
the EDIT IMAGE menu.
2. Push W/X to highlight Add Audio.
3. Push  to record up to 60 seconds of audio. The
display updates to show the recorded time.
4. Push  to pause the recorder.
5. Push  when done.
6. Push  to review the audio file or  to save the
audio with the image.
Voice annotation is only available in the .is2 file format and
is stored in the file so you do not need to collate multiple
files at a later time.