Fluke TiS10 - Spot Temperatures; User-Definable Spot Markers

TiS10, TiS20, TiS40, TiS45, TiS50, TiS55, TiS60, TiS65
Users Manual
20
Spot Temperatures
The Spot Temperatures are floating HI and LO
temperature indicators that move on the display as the
temperature measurements of the image fluctuate.
To turn on/off the hot and cold spot indicators:
1. Go to Measurement > Spot Temp.
2. Push W/X to highlight ON or OFF.
3. Push  or  to set the new value.
User-Definable Spot Markers
Depending on your model, up to three adjustable, fixed-
temperature spot markers are available on the display.
Model: available spot markers:
TiS10, TiS20
0
TiS40, TiS45 1
TiS50, TiS55 2
TiS60, TiS65 3
You can use these markers to highlight a region before
you save the image. The marker selection is set as All Off,
One Marker, Two Markers, or Three Markers.
To set a Marker:
1. Push 2.
2. Push W/X to highlight Measurement.
3. Push 1 or Z to view the menu.
4. Push W/X to highlight Markers.
5. Push 1 or Z to view the menu.
6. Push the W/X to highlight the function between
All OFF, One Marker, Two Markers, and Three
Markers.
7. Push 1 or Z to set the marker option and go to
the “Move Marker” display. You will see the Move
Marker icon and the labels on the function buttons
change to Done, Next, and Cancel.
To change the Marker position on the display:
1. Push W X Y Z to move the Marker location
on the image.
2. Push 2 to highlight the next marker. Do Step 1
again.
3. Do Step 2 for a third marker.
4. Push 1 when done.