FLYGT C3356 User Manual

Xylem Water Solutions AB (the Company) was previously named ITT Water &
Wastewater AB. The name change took place in November 2011. This is document is
(i) a document that relates to a product of the Company phased out prior to the name
change; or (ii) an old version of documentation relating to a product that is still being
produced by the Company but which document was published prior to the 1st of
January 2012 . This document may therefore still be marked "ITT". Xylem Water
Solutions AB is no longer an ITT company and the fact that "ITT" may appear on this
document shall not be interpreted as a reference by the Company to "ITT" in the
Company's current business activities. Any use or reference to “ITT” by you is strictly
prohibited. In no event will we be liable for any incidental, indirect, consequential,
punitive or special damages of any kind, or any other damages whatsoever, including,
without limitation, those resulting from loss of profit, loss of contracts, loss of reputation,
goodwill, data, information, income, anticipated savings or business relationships for any
use by you of “ITT”. This disclaimer notice shall be interpreted and governed by Swedish
law, and any disputes in relation to it are subject to the jurisdiction of the courts in Sweden.
If you do not agree to these terms and conditions you should not print this document and
immediately stop accessing it.

FLYGT C3356 Specifications

General

Weight	720 kg - 1100 kg (depending on motor size and configuration)
Material	Cast iron
Discharge Connection	DN 200 - DN 300 (8 in - 12 in)
Frequency	50 Hz
Speed	1450 rpm
Outlet Size	DN 200 - DN 300 (8 in - 12 in)
Type	Submersible Sewage Pump

Summary

Introduction and Safety

Safety Precautions

Covers general safety, message levels, user safety, hazardous liquids, and ex-approved products.

Installation

Pump Installation Basics

General precautions, fasteners, locking device removal, and installation requirements.

Installation Types

Electrical Connections

Covers electrical precautions, requirements, cable specifications, and phase sequence.

Sensor and Cable Connections

Medium-Voltage Cable Preparation

Coolant System and Seal Flushing Connections

Impeller Rotation Check

Operation

Operation Precautions and Noise

Safety rules, warnings, and information on pump noise levels during operation.

Starting the Pump

Step-by-step guide for safely starting the pump, including checks and warnings.

Maintenance

Maintenance Precautions and Service Intervals

Safety guidelines, general checks, and service intervals for inspection and overhaul.

Inspection Procedures

Major Overhaul and Component Replacement

Steps for major overhaul, including insulation checks, oil change, and part replacements.

Impeller and Locking Assembly Procedures

Detailed steps for impeller removal, installation, and locking assembly procedures.