EasyManua.ls Logo

Flymo EasiLife 200 - Page 40

Flymo EasiLife 200
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Message Cause Action
Trapped
The product has got caught in some-
thing.
Free the product and rectify the reason
for it becoming trapped.
The product is stuck behind a number
of obstacles.
Check if there are any obstacles which
make it hard for the product to move on
from this location. Remove the obsta-
cles or create an island around the ob-
stacles. Refer to
To make an island on
page 17
.
Empty battery
The product cannot find the charging
station.
Check that the charging station and the
guide wire are installed in accordance
with the instructions. Refer to
To install
the guide wire on page 21
.
The guide wire is broken or not connec-
ted.
Check if the indicator lamp in the
charging station flashes yellow. Refer
to
Indicator lamp in the charging station
on page 45
. Find out where the break
is and rectify it.
The battery is spent. Replace the battery. Refer to
Battery
on page 36
.
The charging station’s antenna is de-
fective.
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 45
.
Wrong PIN code
Wrong PIN code has been entered.
Five attempts are permitted, and the
keypad is then blocked for five minutes.
Enter the correct PIN code. Contact
Flymo customer service if you forget
the PIN code.
No drive
The product has got caught in some-
thing.
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
The work area includes a steep slope. Steep slopes should be isolated. Refer
to
To examine where to put the boun-
dary wire on page 16
.
The guide wire is not laid at an angle
on a slope.
If the guide wire is laid on a slope, it
must be laid at an angle across the
slope. Refer to
To examine where to
put the guide wire on page 19
.
Wheel motor over-
loaded, left/right
The product has got caught in some-
thing.
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Wheel motor
blocked, left/right
Grass or other object has wrapped
around the drive wheel.
Check the drive wheel and remove the
grass or other object.
40 - Troubleshooting 1392 - 001 -

Other manuals for Flymo EasiLife 200

Related product manuals