Element Alto7
© 2003 - 2017 ... Naviter d.o.o.
2.2.3 Reboot
In the event your Element Alto locks up, you may perform a hard reboot by removing the batteries for 5
minutes before replacing them and restarting the device.
2.2.4 If exposed to water
The Element Alto is not water resistant! Exposure to water or any other liquid will cause serious damage.
In case your Element gets wet, remove the batteries immediately to prevent more damage. If your
Element Alto was exposed to salt water, rinse it in warm, clean, fresh water. Dry your Element Alto
thoroughly and return it to your vendor or directly to Naviter for servicing.
2.2.5 Warranty
Naviter provides a 2-year warranty on your Element Alto, and we encourage you to contact us via our
website any time for support. After your warranty has expired we will still repair your Element Alto at a
reasonable charge.
For more details see also:
Limited Warranty
2.2.6 Technical support
Direct all inquiries to your vendor, or directly to Naviter via our website www.naviter.com or via e-mail
on support@naviter.com.
If you need access to your serial number (S/N) or software version follow these steps:
1. Press and hold MENU.
2. Use the arrow keys to scroll to Device, press OK.
3. Use the arrow keys to scroll to About, press OK.
39
To Next Page
Loading...