What to do if the motor loses power on my FMS ASW-17?
If your FMS Toy aircraft's motor loses power, land it immediately and recharge the flight battery. Also, check the connection from the ESC to the receiver.
How to fix FMS ASW-17 when it won't respond to throttle?
If your FMS Toy aircraft will not respond to the throttle but responds to other controls, ensure the ESC is armed by lowering the throttle stick and throttle trim to the lowest settings. Also, check if the throttle channel is reversed and, if so, reverse it on the transmitter.
Why is my FMS ASW-17 flight time so short?
If you experience reduced flight time or the FMS Toy aircraft is underpowered, it could be due to a low flight battery charge. Completely recharge the flight battery. Alternatively, the flight battery may be damaged; replace it and follow the flight battery instructions.
How to reduce propeller noise on FMS ASW-17?
If you are experiencing extra propeller noise or vibration with your FMS Toy, it could be due to several reasons. Check for damage to the spinner, propeller, motor, or motor mount and replace any damaged parts. Also, ensure that all propeller and spinner parts are tightened correctly. Finally, verify that the propeller is installed correctly; if not, remove and reinstall it properly.
What to do if FMS ASW-17 motor pulses then loses power?
If the motor power pulses and then loses power on your FMS Toy, inspect the servos for any damage. Additionally, check the linkages for any binding.
Why are the controls reversed on my FMS ASW-17 Toy?
If the controls on your FMS Toy are reversed, perform the control direction test and adjust the controls for both the aircraft and the transmitter to correct the channel reversals.
What to do if control surface doesn't move on FMS Toy?
If a control surface on your FMS Toy does not move or is slow to respond to control inputs, inspect the control surface, control horn, linkage, or servo for any damage and replace or repair any damaged parts, then adjust the controls. Also, check the wiring connections for any loose connections.
As the user, you are responsible for operating safely to avoid endangering yourself or others or damaging property.
Follow manufacturer instructions for Li-Po battery use and disposal to prevent fire, damage, or injury.
Use a Li-Po compatible charger and a heat-resistant surface or fire bag when charging flight batteries.
Bind your receiver with your transmitter. Ensure control sticks are neutral and throttle is off before testing controls.
Balance the model by adjusting the battery so it is level or slightly nose down, typically 70-80mm from the leading edge.
Addresses issues like no motor response, extra noise, reduced flight time, control surface problems, and reversed controls.
Explains protection functions such as start-up failure, over-heat, and throttle signal loss protection.
Provides solutions for common ESC issues like motor not working or abnormal alert tones.
Step-by-step instructions for entering program mode, selecting items, setting values, and exiting ESC programming.
To Next Page
General