16
Connecting Scarlett 2i2 to loudspeakers
The ¼” jack outputs on the rear panel can be used to connect monitoring speakers. Self-powered
monitors incorporate internal amplifiers with a volume control, and may be connected directly.
Passive loudspeakers will require a separate stereo amplifier; in this case, the outputs should be
connected to the amplifier’s inputs.
RIGHT LEFT
RIGHT LEFT
The line outputs are 3-pole (TRS) ¼” (6.35 mm) jack sockets, and are electronically balanced. Typical
consumer (Hi-Fi) amplifiers and small powered monitors will have unbalanced inputs, either on
phono (RCA) sockets, or via a 3.5 mm 3-pole jack plug intended for direct connection to a computer.
In either case, use a suitable connecting cable with jack plugs at one end.
Professional power amplifiers will generally have balanced inputs; we highly recommend using
balanced cables to connect these to the outputs of the Scarlett 2i2.
NOTE: You run the risk of creating an audio feedback loop if loudspeakers are active when you
are monitoring a microphone! We recommend that you always turn off (or turn down) monitoring
loudspeakers while recording, and use headphones when overdubbing.
Connecting active speakers
Connecting passive speakers
To Next Page
Loading...
