23
OPERATION
1.
2.
3.
4.
PREPARE THE CUTTING UNIT FOR SHARPENING
STEP 1: PLACE THE CUTTING UNIT
NOTE: With the TRAINER MODE set to "ON" the ACCU-Touch 3 controller will guide the operator through the enre
grinding process. The prompts on the screen will guide the operator through the steps required to grind the reel.
Having the TRAINER MODE set to "OFF" will require a more experienced operator to complete the grinding process.
EMERGENCY
FIG. 18
FIG. 19
Press TRAINER MODE "ON"
SELECT LANGUAGE
FIG. 20
To Next Page
Loading...