37
OPERATION
SET TRAVEL LIMITS
Set the TRAVEL LIMITS
GRINDING HEAD CARRIAGE
TRAVERSE icons on the screen. See FIG. 53.
TRAVEL LIMIT SENSORS
the GRINDING WHEEL
GRINDING HEAD CARRIAGE OUT
UNTIL THE GRINDING WHEEL
See FIG. 54. When the GRINDING WHEEL is in
TRAVEL LIMIT SENSOR
SENSOR
TRAVEL LIMIT SENSOR
GRINDING WHEEL
TRAVEL LIMIT SENSOR and then
TRAVEL LIMIT SENSOR.
NOTE: IF THE REEL FRAME EXTENDS PAST THE
REEL ITSELF, MAKE SURE THE TRAVEL LIMITS ARE
SET SO THAT THE GRINDING WHEEL WILL NOT
RUN INTO FRAME WHEN GRINDING.
BELT CLAMP.
TRAVERSE ICONS
WHEELEND OF REEL
TRAVEL LIMIT SENSOR
FIG. 53
FIG. 54
NOTE: Grinding wheel must be posioned o of
the reel if frame allows.
TRAVERSE STOP ICON
FIG. 55
To Next Page
Loading...
