25
OPERATION
12°
BOTTOM OF FLAG
RELIEF ANGLE ADJUSTER
SELECT REEL MANUFACTURER AND DIAMETER
REEL POSITIONER
RELIEF ANGLE ADJUSTER. SEE PAGE 41.
FLAG. See FIG. 26.
Example: On a 7" Jacobsen reel you will set the ACCU-REEL POSITIONER (as shown in FIG. 25) and then
set the relief to the corresponding 12° angle (as shown in FIG. 26). If the reel you are grinding does not t
these parameters see the "GRINDING OTHER CUTTING UNITS" secon on page 50.
RELIEF ANGLE
INDICATOR
FIG. 23 FIG. 24
FIG. 25 FIG. 26
To Next Page
