Force FS Series User Manual

2. Programming Remote Controls
NOTE: The remote controls that are supplied with the garage door
opener are pre-programmed.
a) Press the CODE button. A dot (.) will be indicated in the corner of
the display.
b) Now press the button on the remote you want to use, wait 2
seconds, then press and hold the same button on the remote
again for 2 seconds.
The dot (.) on the display will flash to confirm the code, then turn
off. Repeat the process for additional remotes that need to be
stored.
3. Deleting Stored Remote Controls
Press and hold CODE button until a C is indicated on the display. All
stored remotes will be deleted.
1. Programming Opening and Closing Limits
a) Press and hold SET Button until 1 appears on the display, then
release the button.
The door opener is now in Programming Mode.
b) Press and hold the UP until the door reaches the desired open
position.
NOTE: Fine adjustments can be made by toggling the UP & DOWN
buttons
c) Now press the SET button to confirm the position. The
display will now indicate the number 2.
d) Next press and hold the DOWN button until the door
reaches the desired close position. For fine
adjustments toggle the UP & DOWN buttons.
e) Now press the SET button to confirm the close position.
CAUTION: The door will now cycle the open and close phases
to set the travel limits and force sensitivity adjustments. The
door is now set for normal operation.
PROGRAMMING INSTRUCTIONS
37

Force FS Series Specifications

General

Brand	Force
Model	FS Series
Category	Garage Door Opener
Language	English