27. Insert speedometer gear and cable into transmission. Insert bolt through clamp and tighten to 2.25-
2.82 Nm (20-25 lb-in).
28. Install a jack under the lower control arm. Slowly raise lower control arm until front coil spring is under
tension. Continue to raise lower control arm until steering knuckle can be connected to the upper ball
joint. Install pinch bolt and nut and tighten to 37-50 Nm (27-37 lb-ft).
Item Part Number Description
1 — Converter Clutch Solenoid Connect Wires
2 7A247 Park/Neutral Position Switch
3 7A187 Kickdown Control Shaft Rod
4 7E395 Shift Cable and Bracket
5 — Converter Clutch Solenoid and 3-4 Shift Solenoid
6 7B229 Transmission Shift Cable Bracket
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B39.HTM~gen~ref.HTM
To Next Page
Loading...
