Installation
1. Clean mating surfaces of exhaust manifolds and cylinder heads (6049) of carbon deposits.
2. Position right or left exhaust manifold and exhaust manifold gasket in place to cylinder head and
hand-tighten retaining bolts and studs. Tighten to 20-30 Nm (15-22 lb-ft).
3. Rotate or install oil level indicator tube (6754) to appropriate exhaust stud and install retaining nut if
exhaust manifold was removed. Tighten to 16-20 Nm (12-15 lb-ft). Apply ESE-M4G217-A sealer to
tube prior to installation if tube was removed.
Item Part Number Description
1 9430 Exhaust Manifold, Right
2 N804468-S Stud
3 N804465-S2 Screw and Washer
4 — Bolt
5 N805702-S2 Hex Flange Stud, M8 x
1.25 x 90
6 9430 Exhaust Manifold, Left
7 — Screw and Washer
A — Tighten to 20-30 Nm
(15-22 Lb-Ft)
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B24.HTM~gen~ref.HTM
To Next Page
Loading...
