Ford 2000 - EVERY 300 HOURS; F14. Engine Oil Filter

SERVICING SCHEDULE
SECTION
F
F10. Fluid Levels
Check level and
add
oil,
if necessary, to
(a)
rear
axle and (b) bell pulley
(where
fitted).
F11. Clutch
Check
clutch pedal free travel (see
Section G for specifications).
F12. Clutch
Release Bearing Greaser (where
fitted)
Screw the greaser cap down one half turn
every 50 hours (one
complete turn
if
tractor is used on loader work
continuously).
EVERY 150
HOURS (Figure
F13)
Engine Oil (Engines
operating at temperatures below
10 F
(-12
C))
Run the engine to normal
operating temperature then drain
the engine oil.
Refill
the
engine
with the specified quantity of oil.
Change
the
oil filter
element at every
300 hours.
EVERY 300 HOURS
(Figures F13—F17)
F13. Engine Oil (Engines
operating at temperatures
above 10
a
F
<-12'C),
As 1 50 hours
service.
F14.
Engine Oil Filter
Remove and discard the oil filler element,
and
install
a new element
F15. Fan Belt
Check the condition and tension of the fan
belt. A correctly tensioned belt will
deflect a
0-5
inch
(13
mm) total movement
when pressure
is
applied
midway
between the generator
and crankshaft pulley.
F16. Fluid Levels
Check the oil level of the following
and top up if necessary:
(a)
Transmission
and
(b)
Power assisted
steering (where fitted).
c
'