Ford 2000 - F20. Fuel Filter

SECTION F
SERVICING
SCHEDULE
F17. Fuel
Pump (Ford
3000 and
Ford 5000
only)
Drain the
oil and refill with
fresh oil to the
height of
the level plug
hole. Removo
the cover
and gauze from
the pump
breather, wash
in a suitable
solvent and
reassemble.
EVERY
600 HOURS
(Figures
F18-F24)
F18.
Air Cleaner
(Oil Bath Type)
Remove
the complete
air cleaner
assembly from
the tractor. Remove
the inner
and
outer cups
and discard
the oil. Wash
the cups
and the mesh
screen
inside
the body of
the air cleaner in
a suitable
solvent, and allow
to dry.
Refill
both
cups with
oil to the proper
level, reassemble
the air cleaner
and install
the
assembly in
the tractor.
F19. Fuel Injectors
Swing out the
battery tray
to gain access
to the injectors, remove
the injectors
(see section
G) and have them
checked
by an Authorised
Ford Tractor
Dealer.
F20. Fuel
Filter (Single—
where fitted)
Close the fuel
tank shut-off
valve and remove
the filter
bowl from the filter
body.
Discard the
element and the
element sealing
rings. Wash
the bowl and
body
with a brush
and clean
fuel. Install a new
element
and sealing rings.
Absolute
cleanliness
must be
observed during
this operation.
Open the
fuel tank shut-off
valve
and bleed
the fuel system
as detailed in
section G.
F21.
Valve Tappet
Clearance
Swing
the battery tray
outwards to
gain access
to the rocker
cover. Check
the
valve
tappet clearances
as detailed in
Section
G.
F22.
Fluid Level
Check
the oil level in the
steering
box by first removing
the
left-hand steering
shroud
then the combined
level and
filler plug. If
required top
up the oil
to the
level
of the filler
plug hole.
10
I
Gl
I
11