EasyManua.ls Logo

Ford 2000 - EVERY 1200 HOURS OR ANNUALLY

Ford 2000
59 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SERVICING
SCHEDULE SECTION F
F23. Front
Wheel Bearings
Clean and
examine
the
front wheel bearings and their housings. Repack with
grease
and re-install.
Section
G gives the
detailed procedure for this
operation.
F24. Grease
fitting (Highway only)
Lubricate the speedometer
drive assembly
by
removing the
filler
plug and
cover screw, and injecting grease into the
filler
hole
until clean grease is
expelled from the
cover screw hole. Replace the plug
and screw.
EVERY
1200 HOURS OR
ANNUALLY
(whichever
occurs first) (
Figures F25—F29)
F25. Fuel
Filters (Double
where fitted)
Change both filter
elements as outlined in the 600
HOUR service. Bleed the
fuel system as detailed in
section
G.
F26.
Transmission Oil
With the oil hot
remove the drain plug and allow all the oil to drain. Remove
the
level and filler plugs and
replace
the
drain plug. Refill with oil of the
specified
grade up
to the level plug hole
(dipstick mark on Ford 5000).
F27. Rear Axle
Oil
With
the lift arms lowered and any
external rams retracted remove the rear axle
drain plug
and allow the oil to dram. Remove the
level and filler plugs and
replace the
drain plug. Add new oil of the specified type
until it reaches the
level plug hole. Start the
engine, fully raise the lift arms and extend any
external
rams, then add oil to
bring
the
level
up
to the level plug hole once again.
F28. Power
Assisted Steering Pump Oil
Filter
Element
Replace the filler element by first
detaching the complete pump assembly
from
the
tractor, draining the
oil from the reservoir, removing the reservoir and
finally the
element. Before detaching the pump from the
tractor thoroughly
clean the assembly and
observe absolute cleanliness
throughout
the dismantling
operation. Clean the
reservoir and, using the two locating lugs on the pump,
re-install the pump assembly on the
tractor. Fill the reservoir with fresh oil, start
the engine
and turn the steering from lock to lock to
expel any air from the
system. Top up
the reservoir with oil to the bottom of the filler neck.
13

Other manuals for Ford 2000

Related product manuals