Ford 2000 - SEASONAL SERVICES

SECTION
F
SERVICING
SCHEDULE
SERVICING SCHEDULE
SECTION F
F29.
Belt Pulley
(where
fitted)
Discard
the lubricating
oil
by removing
the pulley
assembly
from the PTO
shaft
removing
the
filler/drain
plug
and inverting
the
pulley.
To refill with
fresh
oil it
will be necessary
to temporarily
position
the
pulley on
the PTO
shaft to
fill with
oil correctly
to
the level
hole. Replace
the
level plug,
locate
the pulley
in
the
position
required
and
secure with
the four
attaching
bolts.
Rear Axle and Hydraulic Lift
System
On tractors
fitted with an engine mounted, piston type hydraulic pump (Ford
2000 and 3000, and Ford 4000 Transmission PTO) improved hydraulic
system
action can be achieved in cold weather
by
mixing
a Blending Fluid with the
specified rear axle lubricant.
For
all locations
except North
America
the Ford
Blending
Fluid Part Number is ESNM99C-69-A. For North America the Ford
Part Number is M-4864-D.
Use the Blending Fluid
in
the following proportions:
—
EVERY
2400
HOURS
Hydraulic
Filters
Both inlet
and exhaust
oil filters
in the
hydraulic
system
should
be inspected
by an Authorised
Ford
Tractor
Dealer
and replaced
if
necessary.
SEASONAL
SERVICES
Radiator
Coolant
ffiguta
F30J
Drain and
flush the
radiator
every 24
months
where
a 50%
solution
of 'perma-
nent
(Ford Part
No. ESEM97B-18C)
anti -freeze
is
used. Refill
the radiator
with
bU%
permanent'
anti-freeze
and
50%
water.
i
i
ESNM99C-69-A
M-4864-D
10% fluid to 90% oil for temperatures
between
^
20 F
andO F(—
7 Cand
—
18 C)
20% fluid
to 80%
oil for temperatures
between OF and
—
20 F
(—
18 C and
—29
C)
50% fluid to 50% oil for temperatures
between
4-20
Fand
—
20 F (—7 Cand— 29
CJ
Any additional oil required
to
should be blended as above.
to the level plug or required for auxiliary rams
To prevent premature rear axle wear tractors having
a
blend
of ESN M99C-69-
A
must have tho rear axle oil drained
and
refilled
annually. When the ambient
temperature reaches -40
F (4 C) tractors having F to
—
20 F (—18 C
to
—29
C) blend of ESNM99C-69-A or the M4864-D blend must have
the oil
drained and replenished with one of the following non-blended
oils:
Ford 2000 & 3000 SAE 20W/30 or SAE 80EP
Ford 4000 Ford ESN-M2C53-A or Ford ESEN-M2C86-A
14
15