Keys and Intelligent Access
ActionMessage
A reminder to press the brake while starting your vehicle.To START Press Brake
The system does not detect the key. See Keyless Starting
(page 165).
No Key Detected
When you press the Start Stop button to shut off the engine,
the system does not detect an Intelligent Access key inside
your vehicle.
Restart Now or Key is
Needed
Your vehicle is in the run ignition state.Full Accessory Power
Active
There is a problem with your vehicle’s starting system. Contact
an authorized dealer for service.
Starting System Fault
You have successfully programmed an intelligent access key
to the system.
Key Program Successful
You have failed to program an intelligent access key to the
system.
Key Program Failure
You have programmed the maximum number of keys to the
system.
Max Number of Keys
Learned
You have not programmed enough keys to the system.Not Enough Keys
Learned
The key battery is low. Change the battery as soon as possible.
See Remote Control (page 49).
Key Battery Low Replace
Soon
Informs you that you are exiting your vehicle with the intelli-
gent access key and the engine is on.
Engine ON
122
Explorer (TUB), enUSA, First Printing
Information Displays
To Next Page
Loading...
