3. Push down both red levers to open
the locking mechanism.
4. Remove the seat.
Installing the seats
WARNINGS
To avoid injury, take care when
folding the seats down.
Make sure that the locking hole on
the floor is clear of sand, rock or any
objects which may prevent the seat
from locking.
Note:
Make sure the locking mechanism
is fully open.
Holding the seat at an angle of
approximately 45 degrees to the floor,
lower the seat onto the retaining bar.
Before folding the seats back down, pull
the lower bar on the rear of each seat and
check that the latches are in the extended
position.
Push the seat back down until it engages.
117
Seats
To Next Page
Loading...
Need help?
General
