40
Maintenance
Checking the Latch fully returns after lowering bed.
• With body raised, deploy the body prop by pulling on the handle and
rotate it until it stops.
• Lower the body until it stops. Body prop should be in location within cup
on underside of bed floor.
• Remove keys from ignition.
With the load bed lowered onto the body prop, check that the actuating piston
has retracted into the cylinder and that the Latch has returned to the vertical
position shown in photo below.
The limit switch beneath the Latch should also have returned to the vertical,
positioned within the detent on the cam at the base of the latch, see photo
below.
The external warning buzzer should cease operating with the Latch in the
'Latched' position.
Latch and warning buzzer switch in the 'Latched' position
To Next Page
Loading...
Need help?
General
