43
Electrical
Fuse Replacement
Do not modify the electrical system of your vehicle in any way. Have
repairs to the electrical system and the replacement of fuses carried
out by properly trained technicians.
Switch the ignition and all electrical equipment off before attempting to
change a fuse.
The Tipper Control System will not prevent the vehicle auxiliary battery
from being drained. Ancillary or aftermarket electrical equipment such as
beacons, work lamps etc could drain the battery. To ensure adequate
battery levels are maintained do not repeat tip cycles without the
engine running.
Only fit a replacement fuse with the same rating as the fuse removed.
CAUTION
WARNING
Control Circuit Fuse:
The Control Circuit Fuse is located on the side of the Tipper Control Station.
The fuse is a 5A blade type.
To Next Page
Loading...
Need help?
General
