Fortinet FAP-U43 F Series - Configuring SSID; Enable or Disable Radio

Planning AP Location 19
Configuring SSID
sitesurvey ssid <radio_index> [<ssid>]
Where,
• radio_index can be 0 or 1
• Enter 1 for radio 0 (2.4 Ghz)
• Enter 2 for radio 1 (5 Ghz)
• Enter 3 to specify SSID for both the radios
This command configures SSID for the specified radio. By default, SSID for radio 0 (2.4Ghz) is
set to Fortinet_Site_Survey_2.4 and SSID for radio 1 (5 Ghz) is set to Fortinet_Site_Survey_5.
Examples
ss > sitesurvey ssid 3
FORTINET_SITE_SURVEY SSID is assigned for both radio1 and
radio2 as fORTINET_SITE_SURVEY
ss > sitesurvey ssid 1 <?]?] if SSID is not specified SSID is
assigned to radio1
as FORTINET_SITE_SURVEY_2.4 by default
ss > sitesurvey ssid 2 <?]?] if SSID is not specified SSID is
assigned to radio2
as FORTINET_SITE_SURVEY_5 by default
When using the GUI, the browser window will reset after 3600 seconds of inactivity, irrespec-
tive of the time set for inactivity. The browser refresh time cannot be changed.
ss > sitesurvey ssid 3 <?]?] if SSID is not specified FORTINET_SITE_-
SURVEY_2.4 is assigned as SSID for radio1
FORTINET_SITE_SURVEY_5 is assigned as SSID for radio2.
After configuring SSID on AP radios, you can use the following command to selectively (per
radio) enable or disable broadcasting SSID.
sitesurvey publishssid <radio_index> [on|off]
By default, SSID for both radios are broadcast.
Enable or Disable Radio
sitesurvey {radio | r} <radio_index> [on|off]
Where,