To Connect to the CLI:
You can configure all FortiWiFi configuration options from the CLI
using config commands. The CLI also includes get, show, diagnose,
and execute commands for performing various configuration and
monitoring tasks.
1. Connect the FortiWiFi unit console port to the management
computer using the provided console cable.
2. Start a terminal emulation program on the management computer.
Use the following settings:
• Baud Rate: 9600
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow Control: None
3. Press Enter on your keyboard to connect to the CLI.
4. Type admin in the Name field, leave the Password field blank, and
press Enter.
You can now proceed with configuring your FortiWiFi unit.
To reset the unit to factory defaults
1. Enter the following commands:
execute factory reset
Note: The device will take approximately nine minutes to complete a
factory reset.
To Next Page
Loading...
Need help?
General