FortiGate-50A Installation Guide Version 2.80 MR5
FortiGate-50A Installation Guide 01-28005-0017-20041101 25
NAT/Route mode installation
This chapter describes how to install the FortiGate unit in NAT/Route mode. For
information about installing a FortiGate unit in Transparent mode, see “Transparent
mode installation” on page 35. For more information about installing the FortiGate unit
in NAT/Route mode, see “Planning the FortiGate configuration” on page 20.
This chapter describes:
• Preparing to configure the FortiGate unit in NAT/Route mode
• Using the web-based manager
• Using the command line interface
• Using the setup wizard
• Connecting the FortiGate unit to the network(s)
• Configuring the networks
• Next steps
Preparing to configure the FortiGate unit in NAT/Route mode
Use Tab le 6 to gather the information that you need to customize NAT/Route mode
settings.
You can configure the FortiGate unit in several ways:
• the web-based manager GUI is a complete interface for configuring most settings.
See “Using the web-based manager” on page 26.
• the command line interface (CLI) is a complete text-based interface for configuring
all settings. See “Using the command line interface” on page 28.
• the setup wizard provides easy, fast configuration of the most basic settings to get
the unit up and running quickly. See “Using the setup wizard” on page 31.
The method that you choose depends on the complexity of the configuration, access
and equipment, and the type of interface you are most comfortable using.
To Next Page
Loading...
Need help?
General