Fortinet FortiGate FortiGate-800

42 Fortinet Inc.
Preparing to configure NAT/Route mode NAT/Route mode installation
Advanced NAT/Route mode settings
Use Tab le 11 to gather the information that you need to customize advanced
FortiGate NAT/Route mode settings.
Table 10: NAT/Route mode settings
Administrator Password:
Internal interface
IP: _____._____._____._____
Netmask: _____._____._____._____
External interface
IP: _____._____._____._____
Netmask: _____._____._____._____
Default Gateway: _____._____._____._____
Primary DNS Server: _____._____._____._____
Secondary DNS Server: _____._____._____._____
Internal servers
Web Server: _____._____._____._____
SMTP Server: _____._____._____._____
POP3 Server: _____._____._____._____
IMAP Server: _____._____._____._____
FTP Server: _____._____._____._____
If you provide access from the Internet to a web server, mail server,
IMAP server, or FTP server installed on an internal network, add the IP
addresses of the servers here.
Table 11: Advanced FortiGate NAT/Route mode settings
External
interface
DHCP:
If your Internet Service Provider (ISP) supplies you with
an IP address using DHCP, no further information is
required.
PPPoE:
User name:
Password:
If your ISP supplies you with an IP address using PPPoE, record your
PPPoE user name and password.
DHCP server
Starting IP: _____._____._____._____
Ending IP: _____._____._____._____
Netmask: _____._____._____._____
Default Route: _____._____._____._____
DNS IP: _____._____._____._____
The FortiGate unit includes a DHCP server that you can configure to
automatically set the addresses of the computers on your internal network.