Fortinet FortiSIEM 500F - Command Options for Migration; Restore HTTP Password File; Re-Register to the Supervisor

Migrating from Pre-6.1.2 FortiSIEM
The options for the command are described in the following table:
Option Description
-r The FortiSIEM component being configured
-z The time zone being configured
-i IPv4-formatted address
-m Address of the subnet mask
-g Address of the gateway server used
--host Host name
-f FQDN address: fully-qualified domain name
-t
The IP type. The values can be either
4
(for
ipv4
)
or
6
(for
v6
)
Note:
the
6
value is not currently
supported.
--dns1, --dns2 Addresses of DNS server 1 and DNS server 2.
-o Installation option.
-z
Time zone. Possible values are
US/Pacific
,
Asia/Shanghai
,
Europe/London
, or
Africa/Tunis
--testpinghost The host used to test connectivity
11.
The script will take some minutes to run. When it is finished, migration is complete.
12.
Log in to your system again as user root with your new password.
13.
To ensure phMonitor is running, execute the phstatus command, for example:
# phstatus
Restore the HTTPPassword File From Backup
Run the following command to restore the HTTP password file.
# cp -far /images/passwds /etc/httpd/accounts/
Make sure that the permissions are correct, for example:
[root@co56120 ~]# ls -la /etc/httpd/accounts/
total 8
drwxr-xr-x 2 root root 34 Nov 3 09:47 .
drwxr-xr-x 6 root root 121 Oct 29 18:02 ..
-rw-r--r-- 1 root root 62 Nov 3 13:36 passwds
Re-Register to the Supervisor
Run the following command; note the update option. This keeps old associations.
# /opt/phoenix/bin/phProvisionCollector --update <user> <password> <Super IP or Host>
FortiSIEM 6.1.2 500F Collector Configuration Guide 24
Fortinet Technologies Inc.