Fortinet FortiSIEM 500F - Step 4: Configure FortiSIEM via GUI

Appliance Setup
Note this password—you will need it in a later step.
4.
Run get to check the available FortiSIEM commands.
5.
Use the below commands to check the hardware information. After running each command, ensure that there are
no errors in the displayed output.
Command Description
get system status
Displays system name, version and serial
number.
diagnose hardware info
Displays system hardware information like
CPUs, Memory and RAID information.
diagnose interface detail
port0
Displays interface status.
Step 4: Configure FortiSIEM via GUI
1. Log in as user root with the password you set in Step 3 above.
2.
At the command prompt, go to /usr/local/bin and enter configFSM.sh, for example:
# configFSM.sh
A simple GUIwill open.
3. In the GUI, select 1 Set Timezone and then press Next.
FortiSIEM 6.1.2 500F Collector Configuration Guide 5
Fortinet Technologies Inc.