Fortinet FortiSIEM 500F - Appliance Setup; Fresh Installation; Step 1: Rack mount the FSM-500 F Appliance; Step 2: Power On the FSM-500 F Appliance

Appliance Setup
This document describes how to setup the FSM-500F appliance.
l
Fresh Installation
l
Factory Reset
l
Upgrading FortiSIEM Collector
l
Appliance Re-image
Fresh Installation
l
Step 1: Rack mount the FSM-500F Appliance
l
Step 2: Power On the FSM-500F Appliance
l
Step 3: Verify System Information
l
Step 4: Configure FortiSIEM via GUI
l
Step 5: Register Collectors
l
Step 6: Using FortiSIEM
Step 1: Rack mount the FSM-500F Appliance
1. Follow FortiSIEM 500F QuickStart Guide to mount FSM-500F into rack.
2.
Connect FSM-500F to the network by connecting an Ethernet cable to Port1.
Before proceeding to the next step, connecting Ethernet cable to Port1 is required for Network
configuration.
Step 2: Power On the FSM-500F Appliance
1.
Make sure the FSM-500F device is connected to a Power outlet and an Ethernet cable is connected to Port1.
2.
Power On the FSM-500F device.
Step 3: Verify System Information
1.
Connect to the FSM-500F appliance using VGA port or Console port.
2.
Login as user root with password ProspectHills.
3.
You will be asked to change your password. Once you change the password, you will be logged out. Login again
with your new password.
FortiSIEM 6.1.2 500F Collector Configuration Guide 4
Fortinet Technologies Inc.