Foscam R2C - Micro-SD Card

3
 Microphone: Built-in microphone.
 Micro SD Card slot: Supports up to 64GB SD card for storing the video.
 WPS/Reset
 WPS: Push both WPS/Reset button on the camera and wireless router within 1 minute, the
camera will connect to the wireless router automatically, in WPS process, the Network light will
blink every 0.4 seconds;
 Reset: Push and hold the WPS/Reset button for more than 10 seconds to set the camera to
factory default, the Power light will blink every 0.4 seconds;
Rear panel:
 LAN: 10/100 Mbps RJ-45 port for wired connection
 Power: DC 5V/2A Power supply.
 Speaker: Built-in speaker
 Antenna: Used to connect external wireless antenna
The flashing status of the Power light and Network light are shown in the following table.
Light
Flashing Status
Description
Power light
off
The power don't work properly.
on
The power supply works fine.
Flashing every 0.4 seconds
Reset to take effect
Network light
off
No Wireless connection
Constant Flash
Wired connection
Slow Flash every 1.0 second
Wi-Fi connected
Flashing every 0.4 seconds
WPS is connecting
Flashing every 0.2 seconds
EZLink takes effect
1.5 Micro-SD Card
This camera supports Micro SD Card.
When you plug in the Micro SD card during the camera work process, please reboot the camera again,
or else the Micro SD Card may be cannot work well.
Go to the SettingsDevice StatusDevice Status page, you can see the Micro SD card status.