6.1.5 How to setup alarm recording to SD card
For the cameras that support Mirco SD card, we can save alarm recording on Mirco SD card and below
are the steps to set it up:
Step 1: Setup the Motion Detection Settings
Please go to Settings > Alarm > Motion Detection menu.
(1) Click Enable.
(2) Choose Recording for the alarm action.
(3) Set the Detection Area
(4) Set a Schedule.
(5) Click Save to save the settings.
Note:
1) Please DO NOT forget to set the alarm schedule, the alarm schedule is red.
2) Please make sure your camera time is correct.
3) Please DO NOT forget to set the alarm area, the detected area is covered by the red grids. Or for
some models you can setup 3 detection zones in total.
Step 2: Setup the Storage Location
Go to Settings > Record > Storage Location, and set the “Recording Location” to “SD card and click
Save.
To Next Page
Loading...
