11) Door Change from Right Hand Hinging to Left Hand Hinging.
Remove the door as in 10.
Drill out the two pop rivets and remove the door handle.
Remove the nylon bush from the right-hand side of the door and insert it into the hole in the left-hand side of the
door.
Refit the handle to the right hand side of the door using 3/16 pop rivets.
Unscrew the top pivot pin from the captive nut in the right hand side of the top plate and screw it firmly into the
captive nut on the left-hand side of the top plate.
Note:- it is recommended that a small amount of Locktite or an alternative is used on the thread to reduce the risk
of the pivot pin becoming unscrewed.
Replace the door as in 10
12) Door Gasket Replacement.
Open the door fully.
Whilst holding the door firmly with one hand pull the gasket from its retainer.
Offer the replacement gasket to the cabinet and force the top right and left-hand portion of the gasket into the
retainer.
Once secured into place use a rubber mallet to knock the gasket firmly into the retainer.
Check the gasket is held securely in place, if not continue with the rubber mallet until it is firmly in place.
To Next Page
Loading...
