Fostex XR-7 - Overdubbing Part 2

Basic operation (Start recording)
STEP 4: Overdubbing - 2
In STEP 3, we have recorded new sound sources on track 3 while monitoring the signal from
tracks! and 2. In STEP 4, we will record four sound sources on track 4 while monitoring the
signals from tracks 1, 2, and 3. °
Each sound source is recorded on a track as follows:
Sound sources A, B, C, and D - ► Track 1 (already recorded)
Sound sources E and F ^ Track 2 (already recorded)
Sound sources G and H Track 3 (already recorded)
New sound sources I, J, K, and L Track 4
Preparation and tips
* Before you begin, initialize the controls of the XR-7.
☆ Insert the tape and rewind it to the location at which you want to begin recording.
☆ To monitor the playback signal, it will be routed to the [FB].
* In this example, effect unit 1 applies an effect to sound sources I and J.
[Tl Connect new sound sources
• Connect new sound sources (I, J, K, L) to the [INPUT] jacks 1-4.
[INPUT SEL] switch settings
• Set the channel [INPUT SEL] switches to "INPUT."
f3l [MON SEL] switch settings
• Set the switch to "ST+FB."
26