EasyManuals Logo

Fox F28-191 User Manual

Fox F28-191
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
36
a yellow line) is the earthing conductor. If you must repair or change the supply cable, do not
connect the earthing conductor to a low tension terminal.
Consult a qualified electrician or a person in charge of the maintenance if you have not
understood or you have some doubts on the earthing instructions.
If the supply cable is damaged it must be changed by qualified people. Do not switch on the
machine if the supply cable is damaged.
This tool is provided with a plug which must connected to a suitable socket.
EXTENSION CABLES
Only use three conductors extension cables, with a plug with two plugs and a earthing
contact and sockets with two holes and a earth corresponding to the plug of the tool. When
using an electric tool at a remarkable distance from the power supply, use an extension cable
with sufficient dimensions to transport the current which the tool needs. If the extension cable
has not the sufficient dimensions a voltage drop can occur, thus causing an overheating and
a voltage loss. You can only use extension cables which are in compliance with CE
standards.
Extension cable length: up to 15 m
Cable dimensions: 3 x 2,5 mm²
Before using any kind of extension cable, check that it has not bare wires and that the
insulation is not cut or worn. Repair and change immediately it if it is damaged or worn.
WARNING:
Extension cables must be arranged away from the working area in order that they do not get in
touch with the workpieces, the tool or other parts of the machine, thus creating possible risks.
WARNING:
KEEP THE TOOLS AND THE EQUIPMENT AT A SAFE DISTANCE FROM CHILDREN
This bandsaw has been manufactured for cross cutting and trimming of metal materials (not
hard or tempered metal), non-ferrous metal, plastics, wood.
Maximum cutting height is 160 mm with the workbench at 0°.
The workbench can be inclined up to 45° to angle cut.
RECOMMENDED USE

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fox F28-191 and is the answer not in the manual?

Fox F28-191 Specifications

General IconGeneral
BrandFox
ModelF28-191
CategorySaw
LanguageEnglish

Related product manuals