44
IV. Speed adjustment
By moving the belt on the engine and flywheel pulleys you can use the bandsaw at two
different speeds.
Inside the lower door there are some instructions explaining how to place the belt to obtain two
different speeds.
3. Open the lower door with a screwdriver.
4. Loosen the belt by turning the tensioning knob clockwise.
Move the belt on the desired position, tighten the belt again and close the lower door by
using a screwdriver.
- SMALL ENGINE PULLEY – LARGE FLYWHEEL PULLEY:
blade speed 370 m/min, suitable for hard wood types,
plastics and metal materials (by using a suitable saw
blade).
- LARGE ENGINE PULLEY – SMALL FLYWHEEL PULLEY:
blade speed 800 m/min for all soft wood types.
Caution!
Do not place the belt obliquely, since it would suffer damages.
V. Knob for the adjustment of driving belt
By using the adjustment knob (30) you can adjust driving belt
tensioning:
- Turn the adjustment knob clockwise to reduce
tensioning.
- Turn the adjustment knob anti clockwise to increase
tensioning.
VI. Adjustment of workbench’s inclination
The workbench can be moved from 0 and 45°. To move it, loosen
the lock screw (31), move the workbench to the desired angle and
tighten the screw (31).
VII. Rip fence
The rip fence (33) can be assembled both on the left and on the right
of the saw blade. Choose the position by using a graduated scale,
place the guide and lock it by lowering the front lever.
To Next Page
Loading...
