Step 2: Enter Step and Feed value, and then click the arrow keys to move X, Y, Z axis. If succeed, the
machine is functioning.
E.g.: Step value=10 means moving distance is 10mm. Feed value=500 means 500mm/min
Step 3: Spindle test. Click the button to start the spindle, and adjust the speed to test.
Step 4: Open G-code file
Step 5: Preview Code
Z-
Stop
Y-
X-
X+
Z+
Y+
Note:
It does not represent the actual speed, and it
represents the ratio.
And this percentage is not linear.
II. Software & Debugging
-21-
To Next Page
Loading...