32
3
Integrated Peripherals
► OnChip IDE Device / Onboard Device / SuperIO Device / USB Device Setting
Press <Enter> to go to relative submenu.
OnChip IDE Device
► IDE HDD Block Mode
If your IDE hard drive supports block mode, select [Enabled] for automatic detection of the
optimal number of block read/write per sector.
► IDE DMA Transfer Access
[Disabled] : to disable DMA transfers for all IDE drives. They will revert to PIO mode transfers.
[Enabled] : to enable DMA transfers for all IDE drives. The proper DMA mode will be detected
at boot-up. If the drive does not support DMA transfers, then it will use PIO mode instead.
Recommend leaving this BIOS feature at the default [Enabled] setting. You should only disable
Phoenix - AwardBIOS CMOS Setup Utility
Integrated Peripherals
OnChip IDE Device [Press Enter] Item Help
[Press Enter]
[Press Enter]
[Press Enter]
Press Enter
Phoenix - AwardBIOS CMOS Setup Utility
OnChip IDE Device
IDE HDD Block Mode [Enabled] Item Help
IDE DMA Transfer Access [Enabled]
On-Chip Primary PCI IDE [Enabled]
IDE Primary Master PIO [Auto] If your IDE hard drive
IDE Primary Slave PIO [Auto] supports block mode
IDE Primary Master UDMA [Auto] select Enabled for
IDE Primary Slave UDMA [Auto] automatic detection of
On-Chip Secondary PCI IDE [Enabled] the optimal number of
IDE Secondary Master PIO [Auto] block read/writes per
IDE Secondary Slave PIO [Auto] sector the drive can
IDE Secondary Master UDMA [Auto] support.
IDE Secondary Slave UDMA [Auto]
*** On-Chip Serial ATA Setting ***
On-Chip Serial ATA [Enhanced Mode]
SATA PORT Speed Settings [Force GEN II]
x PATA IDE Mode Primary
SATA Port P1,P3 is Secondary
Enabled
To Next Page
Loading...
